BEL 312314 MSBTE Manual Answer: Basic Electronics

In this article, we share the BEL 312314 Basic Electronics manual answer for electronics and telecommunication branch students.

The following are industry-relevant skills of the competency. Maintaining electronic circuits comprising discrete electronic components is expected to be developed in the student by undertaking the practical of this laboratory manual.

BEL 312314 MSBTE Manual Answer PDF

• Practical No.1: Test the Performance of PN Junction Diode.

• Practical No. 2: Test the Performance of Zener Diode.

• Practical No. 3: Check the Performance of Photo Diode by Varying the Light Intensity as Well as Distance of the Light source.

• Practical No. 4: Construct and Test Half Wave Rectifier on Breadboard.

• Practical No. 5: Build and Test Half Wave Rectifier on Breadboard with Filter (LC filter / π Filter)

• Practical No.6: Prepare and Test the full wave rectifier using two diodes.

• Practical No.7 Build and Test the full wave Bridge rectifier on breadboard using four diodes.

• Practical No.8: Use LC Filter with Full Wave Rectifier to Measure Ripple Factor.

• Practical No. 09: Construct and Test the full wave rectifier on bread board using IC KBU 808 with filter.

• Practical No. 10: Build and Test the performance parameters of 7 Segment LED display FND 507/508.

• Practical No. 11: Identify and select transistors using datasheets.

• Practical No. 12: Build and Test the Performance of BJT Working in CB Mode.

• Practical No. 13: Build and Test the Performance of BJT Working in CE Mode.

• Practical No. 14: Build and Test the BJT voltage divider bias circuit for given input.

• Practical No. 15: Construct and Test the performance parameters of BJT as Switch.

• Practical No.16: Build and Test the performance of Single Stage Common Emitter Amplifier.

• Practical No.17: Simulate and Test output waveform and frequency response of single stage common emitter (CE) amplifier using simulation software (like SPICE / Multisim).

• Practical No. 18: Build and Test the performance of RC coupled two stage amplifiers.

• Practical No. 19: Test the Performance of FET Drain Characteristics.

• Practical no. 20: Check the performance of FET transfer characteristics and calculate transconductance.

• Practical No. 21: Build and Test the performance of common source FET amplifier.

• Practical No. 22: Test the various blocks of regulated dc power supply.

• Practical No. 23: Find out faults at different stages of regulated dc power supply.

• Practical No. 24: Construct and test the performance of Zener voltage regulator for given voltage.

• Practical No. 25: Construct and test the performance of Zener voltage regulator for given voltage.

• Practical no.26: Build and Test the performance of Positive voltage regulator using 78XX , three terminal IC for given voltage.

• Practical No.27: Build and Test the performance of Negative voltage regulator using 79XX, three terminals IC for given voltage.

• Practical no.28: Construct and test the performance of Dual voltage regulator using 78XX and 79XX, three terminals IC for given voltage.

• Practical no.29: Build and Test the performance of LOW voltage regulator using IC LM723 for given voltage.(2 V-7V).

• Practical no. 30: Build and Test the performance of HIGH voltage regulator using IC LM723 for given voltage.(7V-30V)

ENTC All Study Material